Tungsten Karbür Top For Flowmeters
Tungsten Karbür Tops are used where extreme hardness and wear resistance is required; in such applications as bearings, ball screws, valves, flowmeters. Tungsten Karbür Tops are also used for coining and pivots, detents and tips for gages and tracers. Decimal-inch size Tungsten Karbür Tops are widely used for ballizing or hole sizing. Tungsten Karbür Tops are also used for gauging and checking.
Properties
Tungsten carbide itself is practically inert; any attack is usually on the binder. Since other materials are less expensive, the selection of tungsten carbide for corrosion resistance is usually not justified. In severely corrosive conditions, carbides with more resistant binders can be supplied for specific applications.
General Grade
| Grade | Density (g/cm3) | Hardness HRA | T.R.S(MPa) | Performances &applications recommended |
| YG6 | 14.9 | 89.5 | 2150 | Good wear resistance, used for hard wood, processing original wood, aluminum section bar, brass rod and cast iron. |
| YG8 | 14.6 | 89 | 2320 | Suitable for the roughening of cast iron and light alloys and also for the milling of cast iron and low-alloy steel. |
| YG11 | 14.4 | 87.5 | 2260 | Medium grain, for wear parts and mining tools |
| YG15 | 14.1 | 86.5 | 2400 | Medium grain, for mining tools, cold heading and punching dies |